|
Description
Normal Wall switch operation or remote control using any X10 compatible r.f., infra-red, desktop or PC controllers.
Create multiple scenes controls.
Can be controlled by event triggering e.g. motion detection, etc.
|
|
Features
Local and remote control for incandescent lamps.
LED back light night switch indicator
Easy electronic codes setup - within 6 seconds.
Can be controlled using wall switches,or X10 compatible desk-top, wireless infra-red or r.f. handheld controllers. Can even be remotely controlled using phone or PC.
Respond to X10 All Lights ON/All Units OFF command and Bright/Dim commands
Support 2-wires wall connections i.e. no neutral wire required.
Compatible with any X10 remotes, desktops, telephone and PC controllers.
Requires signals to be greater than >100mV and 40W Loads.
|
|
Applications
Operate manually like a normal switch, i.e. tap top for ‘ON’ and hold to brighten or tap bottom for ‘Off’ and hold to dim.
Can be remotely controlled using any X10 compatible transmitter.
Accept ‘On/Off’, ‘All Lights On/All Units Off ‘and Bright/Dim commands.
|
Technical information
Voltage Rating: 230VAC+/- 10%, 50Hz
Incandescent Load: < 300W
Operating Temperature: 10~50degC
Back Size (mm): 43.25(W) x 47(H) x 18.9(D)
|
|
Warning
Incandescent (2-wire) switch can only control resistive load =40W (incandescent lamp or halogen lamps, etc).
It cannot control inductive or capacitive Load (like: Fluorescent lamps?save-energy lamps etc).
|