|
Description
The DAIX10 module is both a dimming actuator and dimmer interface. These modules can be mounted in junction boxes behind a (toggle) pulse switch. By applying the DAIX10, it is possible to switch and dim the lights locally and by remote control.
This module can have be connected to a single or double faced push button: on the first case, a short press (< 0,8s) changes the light status (on – off), while a long press (> 0,8s) allow to dim the light; using a 2 faced push button, the top button allow to switch On/brighten the light (using a short or long press), and bottom button switch Off/dim.
The programming of this module is very simple and can be accomplished in two simple steps: press the built-in push button to place the module in programming mode; send the address you wish to program (e.g. A1) twice, using any remote control.
|
|
Features
- Allows to dim and bright incandescent and halogen lights;
- Stores the last dimming level;
- Low potential inputs, compatible with electric or pulse switches;
- When controlling the internal relay, the X-10 signal is sent to the network. This feature allows, for example, to create a macro to switch off the light 1 minute after being turned on;
- Bi-directional communication: The module responds to status request messages;
- Can be programmed to receive group commands (e.g. All Units Off);
- Status can be retained after the mains has been cut off and switched back on again;
- Compatible with all X-10 devices;
- Higher receiving sensitivity (25mVpp);
- Higher transmit power (5V).
|
Technical information
- Supply voltage: 230V +/- 10% 50Hz;
- Power consumption: <1 W;
- Maximum load: 250W (can be slightly lower if using halogen lamps with electronic transformer);
- Supported loads: resistive;
- Receiving signal sensitivity: 25mVpp;
- Transmit power: 5V;
- Ambient temperature: -10C to +50C;
- Dimensions: 46mm x 46mm x 17mm;
- Able to be installed on switches or wall sockets with, at least, 50 mm depth.
|