|
Description
Switch actuator for installation behind switches, retractive switches, movement sensors, wall sockets or in distribution boxes.
Suitable for remote and/or on-site operation of lighting and equipment.
|
|
Features
- Option of sending alternating ON/OFF commands (toggle);
- Responds to ON and OFF commands;
- Sparkfree activation and deactivation of loads;
- Two independently programmable 230 V inputs (addresses A1-P16) ;
- One input for local relay operation and the transmission of the corresponding ON/OFF command;
- One 230 V input for relay-independent transmission of ON/OFF commands, for example for use as a 230 V interface behind movement sensors;
- Status retention in the event of the loss and recovery of main voltage (bi-stable relay);
- Can be used as actuator for placing behind wall sockets (insulating input wires);
|
Technical information
- Rated voltage: 230 Vac, 50 Hz;
- Rated current: 16 A;
- Current consumption: < 30 mA capacitive;
- Signal transmission: > 5 Vpp in 5 O at 120 kHz in accordance with EN 50065-1, EN 50065-2-1, EN 50065-4-1;
- Transmission synchronization 1 pulse burst at 0°/180°;
- Signal sensitivity 25 mVpp…6 Vpp at 120 kHz ± 4 kHz;
- Signal/noise ratio 1.35 : 1;
- Connection range Up to 2.5 mm2, tightening torque 0.5 Nm;
- Minimum ambient temperature 0 °C;
- Maximum ambient temperature 40 °C;
- Atmospheric pressure 86 pkA - 106 pkA;
- Relative humidity (non condensing) 30 tot 90%;
- Standards NEN-EN-IEC 60669-2-1, NEN-EN-IEC 60669-2-2;
|