The DIX2 allows to send X10 commands (On, Off, Dim and Bright) to 2 different X-10 addresses. Due to its reduced dimensions it can be mounted in a junction box located behind pulse switches.

This module can have be connected to a single or double faced push button: on the first case, a short press sends ON/OFF commands, while a long press (>0,8s) allow to dim the light; using a 2 faced push button, the top button allow to switch on/brighten the light (using a short or long press), and the bottom button to switch Off/dim.

The DIX2 has potential-free inputs, compatible with any push button. Since this module uses bi-directional communication it receives the X-10 commands from the network and updates its internal status.

The programming of this module is very simple and can be accomplished in two simple steps: press the built-in push button to place the module in programming mode; send the address you wish to program (e.g. A1) twice, using any remote control. The other inputs will be assigned with a sequential address (A2 on our example).

• Sends X-10 commands: On, Off, Dim e Bright;
• Receive X-10 commands and updates its internal status;
• Potential free inputs, only compatible with push buttons;
• Compatible with all X-10 devices;
• Higher receiving sensitivity (25mVpp);
• Higher transmit power (5V).

This in-wall module can be used to remotely control any blind. It can be installed behind the switch, near the entrance door of the suite, allowing to control both the ceiling light an the blinds.