|
Description
Some electric devices generate some electric noise and send them to the network. This noise not only affects other devices (for instance, they can cause interference on Hi-Fi stereos) but they can also affect the quality of your X-10 network. Other devices, specially using capacity loads (e.g. UPS) absorb the X-10 signals, avoiding them to reach the destination in the best possible conditions.
The S4813M, is an in-wall module especially design to filter all noise generated from the device connected to it. It supports loads with a maximum of 5A.
For additional information about X-10 noise and interferences, please consult the X-10 Info section.
|
|
Features
- Filters all noise generated by a device;
- Avoid X-10 signal absorption.
|
|
Applications
If you have any problem with your X-10 network, and you feel that a specific device is generating noise or absorbing the X-10 signals, please disconnect the device from the power supply (a TV or similar device, even in Stand-by mode, can generate noise – it is required to unplug it from the wall socket), and try again to send the X-10 signal. If you feel that your X-10 network is more reliable, install the S4813M in-wall module on the wall socket where the device was plugged in.
|
Technical information
- Supply voltage: 230V +/- 10% 50Hz;
- Power consumption: <1 W;
- Maximum load: 5A;
- Supported loads: resistive, capacity and inductive;
- Ambient temperature: -10C to +50C;
- Receiving signal sensitivity: 25mVpp;
- Dimensions: 43.25mm x 47mm x 18.9mm.
|