This device is a switch plug-in and is used between a standard Schuko wall outlet and lamps connected to a wall outlet by cable. The unit is rated IP 20 and can therefore be used in dry environments only. The unit is included into a Z-Wave network by a remote control, PC software or any other kind of Z-Wave controller. It switches all kinds of loads. Local operation is possible by pressing the button on the device.
This presence detector using PIR (passive infrared receiver) detects the presence of a person in a room. The units send information to a controller or any other associated Z-Wave device. Up to 4 devices can be controlled from this device. The sensor is a battery-powered device, which is in sleeping state unless an action is detected. After a programmable sleeping time the device wakes up and sends a status information. After this the unit goes back to sleeping modus. Batteries can be changed without unscrewing the device from the door or frame. The unit will give a visual warning on the device and sends a warning to the Z-Wave controller, when batteries need to be replaced. The unit offers a tampering control and sends an alarm message when tampered.
The device has changeable lenses to optimize the monitoring of the room. A built in 60 db siren can be used if the sensor is in security application mode. A built in light sensor can be used to detect ambient light.
The device needs to be included into a Z-Wave network by a remote control or any other Z- Wave controller. For configuration of certain behavior a static controller such as a PC with home automation software or a gateway is required.
The ST814 is a combined Temperature/Humidity Sensor which is designed for both desktop use and wall mountable. The device has a local LCD display which either shows the temperature or the humidity. 4 buttons allow switching between minimum, maximum or actual values, humidity versus temperature and Fahrenheit versus Celsius The device can report its values via Z-Wave and allows to set trigger level for direct control of other Z-Wave device when the measured value hits the trigger point. This makes the ST814 a very powerful and flexible tool to measure environmental values and control device within a Z-Wave network.