The Floor Sensor is ideal suited to measure soil temperature – especially when using a floor heating – and reporting to the Heat-it thermostat. Therefor the sensor can be laid in empty conduits and set into the ground.
This equipment is an electronic wall thermostat for flush mounting in a standard wall box. The thermostat has a built-in Z-Wave chip that can be connected with your Home Automation systems. The thermostat is equipped with a single-pole switch an can handle loads up to 16A/3600W at 230V. The Device can be used with two external temperature sensors and shows the ambient temperature, either in the room or floor. The sensitive cap sense buttons can be used to set new values by lightly pressing.
Heatit Z-TRM2fx is an electronic thermostat for electrical floor heating. The thermostat has a built-in Z-Wave chip that can be connected with Home Automation systems like Fibaro, Futurehome, Smarthings, Homeseer, Vera, Zipato etc.
Heatit Z-TRM2fx is equipped with a single pole switch and it fits most System 55 frames (Elko RS16, Schneider Exxact, Gira, Jung etc.). The thermostat can withstand a load of max 13A /2900W at 230V. At higher loads the thermostat must control a contactor. The thermostat may be connected to two wired external sensors but it hasn't internal temperature sensor.
The thermostat has the capacity of up to 5 associations (relays, wall plugs etc.).
The thermostat is designed for electrical heating. It can also be used for waterborne floor heating when linked with Heatit Z-Water.
Art. 54 305 60
Heatit Z-DIN 616 is a 6 x 16A potential free relays for DIN rail mounting. The module is equipped with 6 relay switches and 6 digital inputs for mounting on a standard M36 DIN rail (EN50022).
The 6 independent relay switches of the Heatit Z-DIN 616 can be freely controlled from the Z-Wave network and be used for many different purposes. All 6 relay switches are galvanically isolated from each other and may be used for controlling AC and/or DC loads. Each relay switch is rated for loads of up to a maximum of 16A.
The 6 digital inputs can be connected to dry contacts, e.g. limit switches, door/window contacts, or push-buttons. Another option is to connect them to open-collector outputs from discrete sensors, e.g. PIR sensors. The 6 inputs of the Heatit Z-DIN 616 may also function as a scene controller and activate predefined scenes in other Z-Wave devices or controllers (by transmitting Central Scene notifications).
The Heatit Z-DIN 616 is powered by a 10 – 24Vdc power supply.
Initiation of Z-Wave inclusion and exclusion is executed by activating a push-button through a little hole in the front of the module. The Heatit Z-DIN 616 is equipped with a LED in the front of the module for different kinds of status indications.
Heatit Z-Relay multipurpose relay module can be used for many different applications. The IP 55 rated casing makes it useful for any outdoor application. Can pull loads up to 16A and 25A.
The relay has three inputs: analog or digital. You can use both analog and digital inputs, or a combination.
Heatit Z-Relay is a multipurpose product and can be used for the following applications:
• Boiler control
• Leakage control
• Temperature control
• Outdoor applications
The relay has 3 analog/digital inputs and can be used with a lot of different sensors and meters, from water meter pulse sensors to NTC temperature sensors.
The relay comes in two different versions, 16A and 25A. They both have firmware updates (OTA), power metering and S2 security.
We are able to make special firmware if a customer has a special requirement.