ET08 provides a "dial tone" and fully replaces a telephone landline for Alarm Control Panel reporting to the central monitoring station when telephone line is unavailable or has been cut or disconnected by PSTN provider. Can detect temporary service suspension by the service provider for technical or billing reasons even if a "dial tone" is still present. (optional extra)
ESIM251 is a microcontroller based device used to inform users about the alarm in automatic or security systems and control one electric appliance -relay.
Alarm and control system ESIM251 works over GSM network.
It works 24/7, it always reacts to the incoming signal.
ESIM251 can control 1 electronic appliance (a relay) sending a password and a special command from a GSM phone of any of the users. You can, for example, turn on the heating, lighting, lift the gates, blinds etc.
The system will ignore requests coming from unknown telephone number or SMS message with wrong password.
Alarm and control system ESIM021 is used to inform a maximum of two users through the GSM network that an alarm has occurred. Users may also control one electrical device via their mobile phones, e.g. they may switch a lighting system on and off or open and close a gate.
ESIM021 may be connected to an intruder alarm control panel. It has two digital inputs (normally open), so that one detection device may be connected independently of the intruder alarm control panel, or alternatively two detection devices may be connected to ESIM021 without needing a control panel.
When a triggered zone is restored to pre-alarm, the system also sends an SMS or voice message confirming that this has been done.
Either user may turn the heating or lighting on or off, open gates, lift blinds etc. by sending ESIM021 a text message. Only one electrical device may be controlled in this way. The system remembers the status of output in the case of temporary electricity failures. The system will ignore requests and calls coming from unknown telephone numbers.
ESIM264 is an Alarm and Control System (GSM Caller) for the security of premises and control or management of electronic devices through GSM network. The basic advantage of the GSM system is the user’s ability to know immediately what’s happening at their home, apartment, warehouse, summer house or other premises even when the user himself is a long way away – in another city or even in another country. It also has a remote control switch to turn on or turn off 4 or more different devices just by sending SMS messages.
System can be armed and disarmed in one of three ways: via keypad EKB3, key iButton® or free-of-chage call from your phone;
ESIM264 supports the CONTACT ID protocol which is required to transmit signals to a Monitoring Station;
ELDES wireless devices can be added to the system using the EWT1 module. This increases the maximum number of Zones to 44 units and the maximum number of Outputs to 44 units;
Automatic Output control – the system may enable / disable individual Outputs automatically when a specified event occurs;
Fault reporting: The system automatically reports if any of the sensors or sirens disconnect from the system;
Battery check option - checks the health of the battery and reports when the battery needs to be replaced;