Close
(0) items
No tiene articulos en su carrito de compras.
TODAS LAS CATEGORIAS
    Filters
    Preferences
    Buscar

    X10

    catalog.orderby
    catalog.pagesize catalog.pagesize.perpage

    Universal Alarm Interface

    €44,99 IVA incluido
    Connects to an existing system and turns on lights when tripped. It has 3 modes of operation:
    In mode 1 the SM10 will turn On all Lamp Modules and Wall Switch Modules set to its House code, and will also turn On any other Modules set to its Unit code, a stereo connected to an Appliance Module, for example. All Lamp Modules and Wall Switch Module are left in the On state when the system is deactivated, but the Module set to the same Unit code as the SM10 will turn Off.
    In mode 2 the SM10 will FLASH all lights connected to Lamp Modules or Wall Switch Modules. All Lamp and Wall Switch Modules will be left in the On state when the system is de-activated but Appliance modules set to the same House code as the SM10 will turn Off.
    In mode 3 the SM10 will turn ON any Module set to the same House Code and Unit Code as the SM10 when the system is activated and turns it OFF when the input contact is opened.
    Set the input switch to A for triggering the interface by a low voltage input (6-8 V AC, DC or audio), to B for triggering the interface by a dry contact closure. Do not connect 220V to the input terminal!
    The SM10 has a test button which allows you to activate it whether or not it is connected to a system. The All light off button allows you to turn off anything which has been turned on by the interface.
    To install the SM10 (is expected to be installed inside the security controller panel) :
    • Connect the system output to the screw terminals.
    • Connect the flying lead to the 230V power supply, most likely at the 230V side of the transformer.

    Paddle for SW10G, LW11G e AW10G

    €4,99 IVA incluido
    Paddle for SW10G, LW11G e AW10G.

    SW10 Shutter switch, in-wall, on / off / dim

    €54,99 IVA incluido
    Nota: este equipo está fuera de stock hasta nuevos desarrollos. En este momento, no está claro que el fabricante vuelva a producir el producto por lo que sugerimos soluciones compatibles:

    INS_2444-422 - Micromódulo de Persianas de INSTEON es compatible con X10 .


    El Mando de persianas Empotrable SW10 está destinado al manejo de sistemas motorizados de Persianas, Toldos, Cortinas. De esta forma podrá controlar mediante el Sistema X-10 el cierre / apertura, tanto parcial como total del sistema de persianas, toldos o cortinas, directamente desde el mando, o de forma remota mediante mandos a distancia, controladores,... del sistema X10.
    El Mando de Persianas Empotrable SW10 recibe las señales X-10 inyectadas en la red eléctrica a través de los diferentes sistemas X-10 (Mando a distancia y Transceptor, Mini Programador, Modulo de control desde PC...) y “Sube” o “Baja” la persiana o toldo motorizado que esté conectada al circuito.
    Es posible su manejo manual, accionando directamente el propio mecanismo de pared.
    Si el mensaje de control es en formato estándar X-10, la unidad puede ser:

    Completamente abierta en respuesta al comando: "ON"
    Completamente cerrada en respuesta al comando: "OFF"
    Ponerse medio abierta en respuesta al comando: "BRIGHT" o "DIM".

    Double-Button Appliance Micro Switch

    €46,00 IVA incluido
    Rating voltage 230V a.c ±10% 50Hz
    Appliance and Fluorescent lamp Load < 800W X 2
    Device power usage < 1W
    Suitable temperature -10 to 50 degrees C
    Back part small size 43.25 X 47 X 18.9mm

    Single Button Wall Lamp Switch Module (2 wires)

    €46,00 IVA incluido
    Normal Wall switch operation or remote control using any X10 compatible r.f., infra-red, desktop or PC controllers.
    Create multiple scenes controls.
    Can be controlled by event triggering e.g. motion detection, etc.

    Double Button Wall Lamp Switch (2 Wires)

    €46,00 IVA incluido

    Double Button Wall Lamp Switch (3 Wires)

    €46,00 IVA incluido

    Interruptor/Regulador inalámbrico extrafino

    €23,98 IVA incluido

    Este Interruptor/Regulador a batería permite de forma inalámbrica a controlar un módulo X10! Como no es necesario ninguna conexión adicional, puede poner el interruptor donde desee. Esto permite la colocación o cambio a las paredes, ventanas, puertas, mesas, etc.

    El SS11 transmite señales de radio a un receptor X10, como el TM13, IRRF7243, etc. que a su vez induce por la red eléctrica existente, permitiendo así encender y apagar la iluminación (o dispositivo) conectado a receptores X-10.

    Switch wireless with 2 buttons

    €19,95 IVA incluido
    Switch wireless with programmable buttons.
    Yo can put it anywhere because it has an adherent surface that lets you install on any wall without additional wiring.

    Wall-mounted Appliance Receiver

    €38,95 IVA incluido
    Replaces the conventional wall switches. Can be controlled remotely via X10 signals. Directly receives the signals sent by X10 commands wireless, requires no tools.

    ebode emiter micromodule

    €18,95 IVA incluido
    The wireless Micro Transmitter allows you to add a switch for extra incandescent, halogen, low-voltage, energy saving and LED light fixtures.

    RMML

    €21,96 IVA incluido
    The Micro Receiver allows the remote control of incandescent, halogen, low-voltage, energy-saving or LED lights.

    ebode Lamp module

    €29,95 IVA incluido
    The RPL is a lamp module, X10 compatible, that receives Powerline signals.
    The dimmer include in this equipment is prepared to control 230V incandescent or halogen loads from 60 to 150W.
    The RPL sends and receives the following commands: X10 ON/OFF, DIM/BRIGHT, ALL LIGHTS ON, ALL LIGHTS OFF and ALL UNITS OFF.
    The module address is electronically programmed.

    Mini Timer

    €44,90 IVA incluido
    It can be programmed so easily as an alarm clock.
    It allows 8 timed events.
    Can be used as na alarm clock.

    emiter / receiver R.F. micromodules pack

    €34,99 IVA incluido
    The MICRO MODULE PACK allows the installation of a wireless controller for incandescent, halogen, low-voltage, energy-saving or LED light fixtures.

    Pack 10 dimming actuator

    €360,39 IVA incluido
    The LW12 is an in-wall module with built-in dimmer that can be installed behind existing momentary switches or wall outlets.

    The LW12 can be controlled with X10 signals via the mains or a momentary switch connected to the LW12. The LW12 has a memory setting for the last dimmer setting and uses SoftStart and SoftDim. The LW12 is the only X10 module that doesn't use a zero wire. This means it can replace a switch without having to use any extra wiring.

    The AW 12 reacts to the standard X10 commands that are: "All Units On", "All Units Off", "All Lights Off" from any X-10 controller set to its house code regardless of unit code or alternatively individual unit control by "On" an "Off" commands.

    House code and unit code are programmed using any X10 compatible controllers. There is an EEPROM that stores the house and unit code even when the power is cut.

    Pack 10 two load appliance in-wall modules

    €227,55 IVA incluido
    The S2268M module allow to control two individual loads, being small enough (43 x 47 x 18,9 mm) to fit behind a wall switch or junction box. It allows to control both internal relay either using any conventional electric switch (push buttons are not supported) or remotely, using any X-10 compatible controller.

    Pack 3 Módulos de aparato de dos cargas

    €106,64 IVA incluido

    Los módulos S2268M permiten controlar dos cargas individuales, siendo lo suficientemente pequeño para caber detrás de un interruptor de pared o caja de conexiones. Permite controlar tanto el relé interno, ya sea usando cualquier interruptor eléctrico convencional (pulsadores no son compatibles) o de forma remota, usando cualquier controlador compatible X-10.

    Este módulo tiene una característica especial que permite el establecimiento de 16 distintas direcciones X-10 para cada relé interno. Esto es muy útil para crear macros.

    Pack 5 Double Button Wall Lamp Switches (2 Wires)

    €155,60 IVA incluido
    Local and remote control for incandescent lamps.
    LED Back light night switch indicator.
    Easy electronic codes setup - within 6 seconds.
    Can be controlled using wall switches or X10 compatible desk-top, wireless infra-red or r.f. handheld controllers. Can even be remotely controlled using phone or PC.
    Respond to X10 All Lights ON/All Units OFF command and Bright/Dim commands.
    Support 2-wires wall connections i.e. no neutral wire required.
    Requires signals to be greater than >100mV and 40W Loads.
    Brightness level memory retention.
    Soft touch push button.

    Pack 5 Double-Button Appliance Micro Switches

    €155,60 IVA incluido
    Rating voltage 230V a.c ±10% 50Hz
    Appliance and Fluorescent lamp Load < 800W X 2
    Device power usage < 1W
    Suitable temperature -10 to 50 degrees C
    Back part small size 43.25 X 47 X 18.9mm

    Pack 5 Single Button Wall Lamp Switch Modules (2 wires)

    €155,60 IVA incluido
    Normal Wall switch operation or remote control using any X10 compatible r.f., infra-red, desktop or PC controllers. Create multiple scenes controls.
    Can be controlled by event triggering e.g. motion detection, etc.

    Pack 5 Single-Button Appliance Micro Switches

    €155,60 IVA incluido
    On/Off control of load (no dimming).
    Conveniently, codes are electronically set and can be programmed in only 6 seconds.
    Ability to control from remote location through computer or telephone interface.
    Responds to the "All Lights ON and All Units OFF" commands.
    Local ‘manual’ control.
    Responsive to weak signals (25mV).
    Built in noise filter.
    Compatible with any X10 controller. Eg. Mini-controllers, Wireless series, Wall switch controllers, Telephone controllers, Computer controllers etc.

    R.F. micromodule pack

    €46,95 IVA incluido
    Radio control of lights and other devices. Easy to use.
    The RMML actuator micromodules can be concealed behind regular switches, ceilings, technical boxes, etc. and can be controlled by the EM, R.F. switch emitter (battery operated), which can be placed anywhere in the wall or furniture.

    Simtone Double gang frame

    €5,23 IVA incluido
    Double gang frame for S2222E, S2223E, S2224E, S2225E, S3160E e S4206E switches.