INDOOR SIREN, with battery, Z-wave EU

This small device allows you to control the door of your garage or heating system, as a smart complement to your alarm system or simply to make all devices smart in your home. As an additional development of the Universal binary Sensor, the FIBARO Smart Implant controls the connected device, can be used for scene control, has a temperature sensor and is compatible with binary sensors. In addition to controlling the devices (ON / OFF), the device reads the sensor data and amplifies the existing Z-Wave network.

FIBARO RGBW Controller 2 is a universal, Z-Wave Plus compatible RGB/RGBW controller.

FIBARO RGBW Controller 2 uses PWM output signal, allowing it to control LED, RGB, RGBW strips, halogen lights and other resistive loads. It can also measure active power and energy consumed by the load. Controlled devices may be powered by 12 or 24V DC.

Inputs support momentary/toggle switches and 0-10V analog sensors, like temperature sensors, humidity sensors, light sensors etc.

The ZWSEC_SCP318 is a system to control warm water heating in general and floor heating installations in particular. It consists of a battery operated wall thermostat installed in the room to be controlled and a relay switch to operate the water boiler. The thermostat can be manually operated by the user or remotely operated via z-wave to set the desired temperature level.

Transmitter

The ZWSEC_SSR303 is a battery operated wall thermostat. Using a big wheel on the device the user can preset the desired target temperature in the room. By verifying the target temperature with the measured real temperature closed to the device the unit decides how to operate a wirelessly attached power switch that is attached to the heater. In parallel a central gateway of z-Wave control software can set the target temperature using Z-Wave. This enables to realize a time scheduled zone heating. The thermostat itself does not have any internal timers but executes the wireless settings (COMMAND CLASS THERMOSTAT_SETPOINT) and the local setup.

The Fibaro Motion Sensor is a universal Z-Wave multi-sensor. Along with detecting motion the device measures the temperature and light intensity. The sensor has a built-in accelerometer to detect any tampering of the device. The Fibaro Motion Sensor is battery powered device and designed to be installed quickly and easily on any surface. The LED indicator signals motion, temperature level, operating mode and can be used to see if device is within the Z-Wave network. The motion sensor can be used for lighting scenes and security monitoring systems.

Need price for quantities? Please contact us!
Chat tool;
Contact form;
Phone: +351 223 744 938 ;
email: [email protected] ;
Skype: EuroX10.com

FIBARO Double Switch 2 is designed to be installed in standard wall switch boxes or anywhere else where it is necessary to control electric devices. FIBARO Switch 2 allows to control connected devices either via the Z-Wave+ network or via a switch connected directly to it and is equipped with active power and energy consumption metering functionality.