This pattress box insert of the manufacturer Duwi is intended to control all kinds of electrical loads. A 230V powered pattress box is needed for installation. The product consists of:
the insert, which can be used with or without local control
a special mounting plate to mount the insert into a pattress box
a mounting frame for Duwi Everlux series , color standard white
the switching paddle for local control of the dimmer
The unit is designed for use within a 3-wire system, which means that a neutral wire (blue) is needed for operations. It will be included and controlled in a Z-Wave network from a remote control, a wireless control centre or any other kind of Z-Wave controller including a PC-software.
The Z-Wave.Me RaZberry turns every Raspberry PI into a Z-Wave smart home gateway. The bundle of hardware and precompiled Z-Wave wireless network management software waits to be completed by your own user interface running in a web browser or a mobile phone.
The RaZberry 2 has an optimized antenna, wherewith the module can achieve a range of up to 200 meters.
Replace your conventional wall switch and control the connected load (e.g. ceiling light) in future via Z-Wave wireless technology. Of course local control via wall switch is still possible as is usual. Besides local connected loads (from 10W to 300W) the wall insert can also switch other devices within the wireless network via Z-Wave. For this two switch groups are available: Single and double click. Therewith scene activation is also possible.
If the Z-wave.me wall is included into a network controlled by a controller that supports Z-Wave all communication with the controller is secure and it only accepts special secure commands. All data that is sent to the controller is secured as well.
This device is working with a 2-Wire system, so no neutral wire is required for it to work.
Rocker switch and installation frame in design Busch-Jaeger DURO 2000 (Creme White) are part of this set.
Suitable for wireless controls Z-Wave actuators such as dimmers, switches, thermostats or motor controls for blinds or jalousies.
Devices can be turned on and off but dimmers and motor controls can also be turned into a desired dimming level to motor position by keeping a button pushed and releasing it.
Additionally the device can act as a primary controller of a Z-Wave network using three dedicated network control buttons located behind a sliding cover.
The remote control can operate as a secondary control beside an IP-Gateway however it is not possible from this device to activate scenes defined in the IP-Gateway. All scenes and control groups are stored within the remote control and they are also conveniently programmed using the buttons of the remote rather than using wireless commands from an IP-Gateway.
Z-Uno is the first and only easy to use developer board that allows you to create your own Z-Wave device without deep knowledge of Z-Wave protocol or programming. Z-Uno is a mix of Z-Wave home automation radio protocol power and Arduino simplicity. Being inspired by Arduino project Z-Uno inherits all concepts of easy-to-use hardware and software solutions, keeping maximum flexibility. Z-Uno is a fully DIY product. It is made for those who are limited by existing choice of Z-Wave products and wants to extend their smart homes with more sensors and actuators: connect LEDs, buttons, switches, motors or any low voltage sensor including most of Arduino compatible sensors. Z-Uno programming is done by writing sketch in simplified C language and loaded into Z-Uno using Arduino IDE. Many examples and comprehensive tutorials will help you to make your own project. Being Z-Wave Plus certified device, Z-Uno is the perfect companion for you RaZberry gateway. Z-Uno is compatible with other controllers too: among them Fibaro Home Center 2/Lite, Vera Edge and Zipato Zipabox.